The PowerG door / window sensor requires one CR2450 battery.
Replacing the PowerG Door / Window Sensor Battery
Share or Print This Article
Solution
1
Insert a coin in the slot and twist gently to remove the cover. 
Note: If a coin is not available, insert a small flat-head screwdriver into the side slot of the plastic cover and twist to open each side.
2
To remove the battery, wedge a flat-head screwdriver under the battery, and then twist the screwdriver using the base as a lever.
3
Insert the CR2450 battery at an angle and press down on the battery until it fits into place.
Note: The writing on the battery should be facing up.
4
Snap the cover into place and ensure it is closed securely to avoid any tamper notifications.
Cox Business MyAccount Updates
Cox Business MyAccount Updates
With the new and improved MyAccount portal from Cox Business, you’re in control. Included with your Cox Business services, it’s all right at your fingertips anytime, anywhere.
- Perform a health check on your services and reset your equipment
- Easily configure key features and settings like voicemail and call forwarding
- View your balance and schedule payments
Search Cox Business Support
Search Cox Business Support
Didn't Find What You Were Looking For? Search Here.
