• Shopping Cart
  • Contact Us
  • Select a Location
    Close Location Selection

    Current Location:

    Let us know the location you'd like to browse.

    Select a Location
    OR

Netgear CM700

Details




Modem Information

DOCSIS 3.0 Cable Modem

32x8 channel bonding

To achieve Gigablast or Ultimate Classic speeds, a DOCSIS 3.1 modem is required

Highest Service Level

Ultimate 500



Front View

Front View

Click to enlarge.

After the cable modem successfully registers on the network, the Power, Upstream, Downstream, and Internet indicators illuminate continuously to indicate that the modem is online and fully operational. For more details, refer to the Modem Lights section.




Back View

Back View

Click to enlarge.


The modem includes the following connection ports:

  • Ethernet - Connects to the Gigabit Ethernet cable.
  • Reset - Use this button in the unlikely event that you want to restore the default factory settings. This button is recessed to prevent accidental resets of your modem.
  • Cable / Internet - Connect your coaxial cable line to this port.
  • Power - Connect the supplied power cord to this port.
  • On / Off - Turns modem on and off.



MAC Address

MAC Address of Netgear CM700

Click to enlarge.


The MAC Address and Serial Number information is located on the bottom of the modem.

Troubleshooting

The lights indicate the current status of your gateway. To troubleshoot any connection problems, use the table below.

Modem LightStatusProblem
Power

power
OffNo power
GreenNone
RedThe cable modem is too warm and might overheat
Downstream

downstream
Blinking GreenScanning for downstream channel
Solid AmberNone - connection established on one channel
Solid GreenNone - operating on more than one channel
OffDownstream channel inactive
Upstream

upstream
OffUpstream channel inactive
Blinking GreenScanning for upstream channel
Solid AmberNone - connection established on one channel
Solid GreenNone - operating on more than one channel
Internet

internet
OffModem offline
Blinking GreenNone - scanning for configuration parameters
Solid GreenNone - operational
Ethernet

ethernet
OffA device is not connected to the Ethernet port on the back.
Solid GreenNone - A device is connected to the Ethernet port.

Manufacturer Resources

For more detailed technical information use the resources below.

Data Sheet (PDF)

Search for More Articles