• Shopping Cart
  • Contact Us
  • Select a Location
    Close Location Selection

    Current Location:

    Let us know the location you'd like to browse.

    Select a Location

Contour Voice Remote Control XR11

Contour 2 XR5 remote control, click for full-size image.

The Contour 2 voice remote can be programmed for TVs and audio devices, and pairs with Contour 2 receivers to enable aim free control.

This remote offers some of the latest features:

  • Voice command – When the remote is paired to a receiver, you can search TV listings and On Demand, find a recorded show, change channels, set a recording, and more, with just your voice.
  • Control your devices
    • TV power, volume, muting, and input control
    • Audio device power, volume, and muting control
  • Aim free control your receiver
    • Works when paired with your Contour 2 receiver
    • Pairs to the receiver through menu
  • All Power button - Turns ON the receiver, TV, and audio device on at the same time, and turn OFF TVs and audio devices

    To turn off the Contour 2 receivers, refer to Turning a Contour 2 Receiver On and Off.

  • Automatic back light
  • Remote LED
    • The remote LED blinks when a command is sent to any device, and during setup and programming
    • In paired RF mode, the remote blinks twice - once when a command is sent, and again when the receiver confirms receipt.

Note: The ability to replay live or recorded TV can be done using one of the following methods.

  • Press Replay to rewind the program 30 seconds.
  • Pressing Pg Up or Pg Down will fast forward or rewind the program by 5 minutes.
  • Speaking into the voice remote can fast forward or rewind the program by the time spoken into the remote. As an example, "Rewind 15 seconds."

The color of the LED indicates whether the remote is operating in infrared (IR) or radio frequency (RF) mode, as shown in the table below.

LED Color Status Action
Green A command was sent and received in RF mode. No action required, the remote is paired to the receiver. If there is latency of more than 5 seconds, unpair and re-pair the remote and receiver.
Green, red A command was sent in RF mode, but receiver did not confirm. Unpair and re-pair the remote and receiver.
Red A command was sent in IR mode. The LED blinks red once for all TV and audio device commands. If the remote LED blinks red after a command to the receiver, such as pressing the GUIDE button, the remote is in IR mode. Unpair and re-pair the remote and receiver for RF operation.
What do you want to do next?

Search for More Articles