Having problems with your Internet Connection? Did you know that most Internet connectivity issues can be solved by using our Modem Reset tool? Just sign-in, click the Reset button, and get back browsing the Web. >> Reset My Modem
Last Updated: Tue, 16 Feb 2016 > Related Articles
Learn about the available ports and an explanation of the status lights on a Ubee DDW 366 dual band WiFi cable modem.
After the cable modem is successfully registered on the network, the POWER, DS/US, and ONLINE indicators illuminate continuously to indicate that the cable modem is online and fully operational. For more details, refer to the Modem Lights section.
The Ubee DDW366 has the following ports available on the back of the WiFi modem.
- USB - Connects to USB devices such as flash drives, hard disk drives, and printers.
- ETH 1-4 (Gigabit Ethernet 1-4 also known as LAN 1-4) - Four 10/100/1000 auto-sensing RJ-45 ports. Connect devices on your LAN (Local Area Network) such as a computer, hub or switch to these ports.
- RESET - Use a pointed object to push down the reset button for less than five seconds to reset the device without losing personal setup. If you want to restore factory resets, push down this button for more than five seconds.
- CABLE - Connect your coaxial cable line to this port.
- POWER - Connect the supplied power cord to this port.
The modem lights indicate the current status of your WiFi cable modem. To troubleshoot any connection problems, use the table below. See Rear Panel Modem Lights view lights related to the Ethernet connection.
|POWER||Off||No power||Verify all cable connections and try resetting the modem. If cable is OK and modem reset does not work, contact Customer Support.|
|Flashing Blue||Power-on failed - briefly immediately after the device is powered on||N/A|
(Downstream / Upstream)
|Flashing Blue||None - once every second while scanning DS, twice every second while registering the US|
Note: A firmware upgrade is in progress when the Power and Online lights are solid.
|Solid Blue||None - locked to US and DS channels and registered OK||N/A|
|Flashing Blue||None - obtaining IP address and configuration file||N/A|
|Solid Blue||None - modem is operational||N/A|
|2.4 GHz||Blue||None - WiFi is enabled at the 2.4 GHz frequency||N/A|
|Off||2.4 GHz WiFi is disabled||N/A|
|5 GHz||Blue||None - WiFi is enabled at the 5 GHz frequency||N/A|
|Off||5 GHz WiFi is disabled||N/A|
|WPS Button||White||Blinks for 4 minutes until a PIN is entered from the wireless client that you are connecting - For example, a laptop computer|
Triggered when you press the WPS button or enable WPS via the device’s user interface. After the device connects successfully, the light remains on for five minutes, then turns off
|Off||WPS signal not in use||N/A|
Rear Panel Modem Lights
The lights below indicate the connection status of your WiFi cable modem. To troubleshoot any connection problems, use the table below.
|ETH1 - ETH4||Off||Device is not connected to the port.||Verify all cable connections and try resetting the modem. If cable is OK and modem reset does not work, contact Customer Support.|
|Flashing Green||None. A device is connected to the port at 1000 Mbps speeds and data is passing between cable modem and connected device.||N/A|
|Flashing Orange||None. A device is connected at 10/100 Mbps speeds and data is passing between cable modem and connected device.||N/A|