The Internet should add convenience, not headaches. From step-by-step instructions to helpful tips, we'll help you install your equipment, troubleshoot problems, and get the most out of your online experience – minus the migraine.
Troubleshooting the Linksys BEFCMU10v3 Cable Modem
Last Updated: Wed, 16 Jul 2014 > Related Articles
Overview of the available ports and an explanation of the status lights on a Linksys BEFCMU10v3 cable modem.
The Linksys BEFCMU10v3 is a DOCSIS 2.0 cable modem.
After the cable modem has successfully registered on the network, the Power, Cable, and USB or Ethernet indicators illuminate continuously to indicate that the cable modem is online and fully operational. For more details, refer to the Modem Lights section.
The Linksys BEFCMU10v3 has the following ports available on the back of the modem:
- POWER - Connects the cable modem to the power adapter.
- RST - Used to reset the modem.
- LAN - Connects to the Ethernet port on your computer.
- USB - Connects to the USB port on your computer.
- CABLE - Connects to the cable wall outlet.
The RST button is for maintenance purposes only. For more details, refer to the Modem Lights section.
None. Power is properly connected.
|Off||No power.||Verify power supply connections and electrical outlet. Also make sure the outlet is not connected to a switch.|
|Searching for cable connection.||Verify all cable connections and try resetting the modem. If cable is OK and modem reset doesn't work, contact Customer Support.|
|Fast Flash Modem||Searching for cable connection.||If this is a new modem or a replacement modem, you must contact Cox with your MAC address Click Here. If there are several MAC addresses on the modem, please use the “HFC” or “RF” MAC address. View MAC Address Label|
|Off||No connection cable connection.||Verify all cable connections and try resetting the modem. If cable is OK and modem reset doesn't work, contact Customer Support.|
|Traffic is passing through the cable modem port.||N/A|
|Ethernet||Solid Green||None. Successfully found the computer through an Ethernet connection.||N/A|
|Off||No Ethernet found.||Verify Ethernet cable connections, the TCP/IP settings and the NIC. You might need to reinstall the NIC drivers. If this does not resolve the issue, contact Customer Support.|
|USB||Solid Green||None. Successfully found the computer through USB connection.||N/A|
|Off||No USB found.||Verify USB cable connections, the TCP/IP settings and the USB cable. You might need to reinstall the USB drivers. If this does not resolve the issue, contact Customer Support.|